This repo contains:
- Original Norsk Data ND-120 CPU Design Documents from 1988. Scanned in 2023
- Modern Logisim and HDL implementation from 2023.
You can read more about this CPU and much more in NDWiki and the official website for Norsk Data
The goal of this repo is to re-create the schematics and create the HDL files so we can program an FPGA to run as the original ND-120 CPU Card.
On the way to the FPGA code, there will be testable Logisim Circuits and Logisim code that can be converted and tested in C++ using Verilator.
The minimum requirements are:
| Component | Schematic | HDL | Status |
|---|---|---|---|
| DELILAH CPU Gate Array (CGA) | Completed | Logisim generated Verilog | QA on schematic/Verilog ongoing |
| NEC Decoder Gate Array (DGA) | Completed | Logisim generated Verilog | QA on schematic/Verilog ongoing |
| ND 3202 CPU Board revision D | Completed | Logisim generated Verilog | QA on schematic/Verilog ongoing |
| PAL Chips | All PALASM code has been validated | Verilog and testcode created | QA on Verilog ongoing |
In the CPU Board we will plug in the DELILAH CPU and the Decoder, all PAL chips and several other support chips (74-series, RAM and UART,++)
Design and implement I/O devices for reading and writing files from FLASH memory simulating the device.
- Floppy
- Hard Drive
All the design documents are in the Design Documents folder.
Functional Description, Instruction set, Microprogramming guide and more are in the NorskData-Doc folder.
The Microcode dump is from a ND-120 3202 CPU Board is Version 14/L The source code is also for the L version.
The ND-120/CX CPU Board has an on-board MC68705-U3 CPU.
The physical front panel also has an MC68705 CPU, however this chip is not identical to the on on the 3202D CPU Board - its an MC68705-P3 with fewer I/O pins.
The MC68705 is an MC 6805 8-bit CPU with on-chip RAM, I/O and Timer. Motorola 68HC05
- P3 version = 28 pins, 2x 8 bits I/O ports, 1x 4 bit I/O port
- U3 version = 40 pins, 4x 8 bits I/O ports
We have a ROM dumps from both the MC68705-U3 chip (from the 3202D CPU Board) and the MC68705-P3 (from an ND-5000C panel controller).
Big thanks to Matthieu Benoit for reading the data out of the chips
Reverse engineering has been done using the free SRE tool GHIDRA from NSA.
All the Logisim files are stored in the Logisim folder
You need to install the Logisim-Evolution design tool from Logisim Evolution Repository
The Logisim diagrams has been drawn with Version 3.8.0
Most Verilog files are generated from the Logisim drawings, using Logisim-Evolution FPGA tools.
All the Verilog files are stored in the Verilog folder
To test the Verilog code using Verilator you need to install the Verilator tool