Skip to content

Latest commit

 

History

History
56 lines (42 loc) · 1.91 KB

10gigE.md

File metadata and controls

56 lines (42 loc) · 1.91 KB

10GigE (Zippier) ZMap

It is possible to build ZMap to run at 95% of 10 GigE linespeed, sending over 14 million packets per second. This requires a compatible Intel 10 Gbps Ethernet NIC and Linux.

Prerequisites

  1. A PF_RING ZC license from ntop.
  2. PF_RING ZC headers and kernel module
  3. A 10 Gbps NIC with compatible "PF_RING-aware" drivers
  4. A Linux (not BSD or Mac) installation
  5. For best results, a computer with at least 8 physical cores on the same NUMA node.

Building

Most build errors are due to incorrectly building or installing PF_RING. Make sure you have build the drivers, the kernel module, and the userland library, as well as install the headers and kernel module to the correct locations.

The PF_RING make install command might not copy pfring_zc.h to /usr/include, in which case manually install the file and set permissions correctly.

To build navigate to the root of the repository and run:

$ cmake -DWITH_PFRING=ON -DENABLE_DEVELOPMENT=OFF .
$ make

Running

You'll have to carefully select the number of threads to use, as well as specify as zero-copy interface, e.g. zc:eth1. Use the --cores option to pick which cores to pin to. Make sure to pin to different physical cores, and note that some machines interleave physical and "virtual" cores.

$ sudo ./src/zmap -p 80 -i zc:eth7 -o output.csv -T 5

Considerations

DO NOT TAKE THIS LIGHTLY!

Running ZMap at 10Gbps hits every /16 on the Internet over 200 times a second. Even if you have a large source IP range to scan from, it's very obvious that you're scanning. As always, follow scanning best practices, honor blacklist requests, and signal benign/research intent via domain names and websites on your scan IPs.

Remember, you're sending a lot of traffic. This is what happened at the University of Michigan during a 10 Gbps scan.